Can one anveo account be setup on more than one Obihai box?

<< < (3/7) > >>

ianobi:
Leave all the rules as they are except the last rule, which is {(Mpli):pli}. Delete {(Mpli):pli} and replace with {(<ob200123456*>(Mpli)):pp}

Remember to replace 200123456 with the actual OBiTALK number of your master OBi. Also where I used 200654321 replace with the actual OBiTALK number of your slave OBi.

You will need to configure a "fake" SIP provider on sp1 of your slave OBi as follows:

Service Providers -> ITSP Profile A -> SIP -> ProxyServer : 127.0.0.1

Voice Services -> SP1 Service -> Enable : (checked)
Voice Services -> SP1 Service -> AuthUserName : 1234
Voice Services -> SP1 Service -> X_RegisterEnable : (unchecked)
Voice Services -> SP1 Service -> X_ServProvProfile : A
Voice Services -> SP1 Service -> CallerIDName : slaveOBi

sp1 will show up on your slave OBi Dashboard as "Registration Not Required".

Now when you dial from the slave OBi anything you dial should route via your master OBi sp1 service.

jesseasi:
Quote from: ianobi on May 06, 2014, 11:53:49 am

Leave all the rules as they are except the last rule, which is {(Mpli):pli}. Delete {(Mpli):pli} and replace with {(<ob200123456*>(Mpli)):pp}

Remember to replace 200123456 with the actual OBiTALK number of your master OBi. Also where I used 200654321 replace with the actual OBiTALK number of your slave OBi.

You will need to configure a "fake" SIP provider on sp1 of your slave OBi as follows:

Service Providers -> ITSP Profile A -> SIP -> ProxyServer : 127.0.0.1

Voice Services -> SP1 Service -> Enable : (checked)
Voice Services -> SP1 Service -> AuthUserName : 1234
Voice Services -> SP1 Service -> X_RegisterEnable : (unchecked)
Voice Services -> SP1 Service -> X_ServProvProfile : A
Voice Services -> SP1 Service -> CallerIDName : slaveOBi

sp1 will show up on your slave OBi Dashboard as "Registration Not Required".

Now when you dial from the slave OBi anything you dial should route via your master OBi sp1 service.



Added each of these line by line - my dashboard still shows up as "Not Configured" for SP1. 

ianobi:
Please check that your changed settings are staying set and not being overwritten by the OBiTALK portal.

I need to sign off for today. I'll be back tomorrow.

joefly:
Wow, I did not expect it to NOT BE able to register with more than one OBi.

Thanks for the idea of master/slave.  I would have to think about this to see if this is necessary for my situation.

related question.

Is there a price Anveo Package where SIP info is given and allowed to registered on more than one OBI?

Thanks

AlanB:
Quote from: joefly on May 06, 2014, 01:25:33 pm

Is there a price Anveo Package where SIP info is given and allowed to registered on more than one OBI?

Thanks


The non ObiTalk plans

Navigation

[0] Message Index

[#] Next page

[*] Previous page