Can one anveo account be setup on more than one Obihai box?
JJ97:
Quote from: AnveoRep on May 06, 2014, 06:00:27 am
c3c3 is correct. You can not setup one Anveo account on multiple OBI boxes.
I believe SIP user/password authentication/registration is required for receiving calls on the SIP OBi device. If another SIP device (e.g. Android softphone) registers, then incoming calls will ring the last registered device. Registration happens every 60 seconds, so the two SIP devices will go back and forth. This is not good.
However, for outgoing calls only, we don't need to register every 60 seconds; and there is an option for this in OBi SPx and Android softphones. I tried this successfully once for making outgoing calls. Nevertheless, does Anveo allow any number of outgoing calls from the same or different SIP devices concurrently? On the Free Starter plan? They would just charge per minute on each of those calls -- Right?
AlanB:
Thanks for the correction.
sailing:
You can create sub-accounts. For each sub-account, you can have a different Obi connect. From within Anveo, you can determine how the phones ring. I believe you can also give each sub-account an extension number that can be used to call between sub-accounts.
jesseasi:
I would like to learn more about this master / slave configuration. I have followed all the steps above - but my "slave" unit stills shows "not configured"
Do I need to manually reboot the unit?
JJ97:
Quote from: sailing on May 07, 2014, 04:04:46 am
You can create sub-accounts. For each sub-account, you can have a different Obi connect. From within Anveo, you can determine how the phones ring. I believe you can also give each sub-account an extension number that can be used to call between sub-accounts.
When creating a sub-account in the USA., Anveo says "E911 address in USA or Canada will be required to make outbound calls." Does this mean I have to pay an additional E911 $0.80/month fee (besides my original account)?
Navigation
[0] Message Index
[#] Next page
[*] Previous page