switched to Phone Power from GV - now I have to dial area code for local calls

(1/1)

jhbObiForum:
I just switched to Phone Power from GV  - now I have to dial area code for local calls.  How can I fix it so that I just dial 7 digits for local calls?

Thanks!

JB

ProfTech:
Most ITSP's require that you dial either 10 or 11 digits, however you can configure the Obi to do it for you if you only have a few "local" exchanges. In some large metro areas the list of area codes and / or exchanges might be too long to make it feasible. 

jhbObiForum:
I only have one area code.  How do I configure the Obi to do this?

azrobert:
Add the following rule to the Primary route DigitMap.
It's usually the ITSP Profile A DigitMap.

<1aaa>xxxxxxx

Where aaa is your local area code.
Rules are separated by a vertical bar.

jhbObiForum:
All set.
Thanks

Navigation

[0] Message Index