The instruction are the same basically.
What service providers do you have set up on the Obi?
Will Circlenet be used for dialing US destinations only?
Are there specific areas you plan to call with Localphone or do you plan to just dial an **3 to select it?
Voice Services >>> Gateways and Trunk GroupsVoice Gateway1
Enable X
Name
circlenet.usAccessNumber SP2(outbound.circlenet.us)
DigitMap (xx.)
AuthUserID Circlenet Account number
AuthPassword Password
Go to
https://www.localphone.com/dashboard/internet_phone/About half way down the page are the SIP ID and SIP Password for the next step.
Voice Services >>> Gateways and Trunk GroupsVoice Gateway2
Enable X
Name
localphone.comAccessNumber SP2(localphone.com)
DigitMap (xx.)
AuthUserID SIP ID
AuthPassword SIP Password
Voice Services >>> Gateways and Trunk GroupsTrunk Group1
Enable X
Name Outbound Route(optional)
TrunkList vg1 (You can put backup service here as well. vg1,sp1,sp2)
Digit Map (xx.)
Physical Interfaces >>> Phone PortPrimaryLine = Trunk Group 1
DigitMap
([1-9]x?*(Mpli)|[1-9]S9|[1-9][0-9]S9|911|**0|***|#|**1(Msp1)|**2(Msp2)
|**3(Mvg2)|**8(Mli)|**9(Mpp)|(Mpli))
OutboundCallRoute
{([1-9]x?*(Mpli)):pp},{(<#:>|911):li},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},
{(<**3:>(Mvg2)):vg2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}
Normal calls will go through Circlenet and dialing **3 before a number should route it through Localphone. This setup does not address 911, 411, or voicemail. Additional changes need to be made to the OutboundCallRoute and some possible optimizations to speed up dialing.
Hope I didn't miss anything.