set codec to G.729a

<< < (2/3) > >>

Shale:
Quote from: DavidTW on May 14, 2014, 03:18:49 pm

I am not sure what I am un-ticking... I can change from OBiTALK to device, but I am not sure what the means.... are you saying I change two from OBiTALK to device, and which two?


You want to change a field that is grayed out in OBITalk Expert mode. Untick the one box under "OBiTALK Settings" . Then untick the box in the Device Default column. That box in the Device Default column was empty gray until you clicked the first box.

DavidTW:
so when I set the priorities,  it still uses G711u.  But when I use the *4729 or disable g711u, it shows
Audio Codec      tx=; rx=

It will ring the other phone, but when it answers it gives a rejected by the service provider for reason 200.

Shale:
Who is your SIP provider?

DavidTW:
Phone Power

Crow550:
Quote from: DavidTW on May 14, 2014, 09:56:39 pm

Phone Power


I would like to know how to set this too.

I know you set it in the Phone Power site's settings for Codec and reboot the Obi box but it doesn't seem to switch.

Same rejected message when using the codec star code when calling out to test....

Navigation

[0] Message Index

[#] Next page

[*] Previous page