VOIPO voicemail
RonR:
BTW, do you have your PrimaryLine set to SP1 Service or is still at PSTN Line?
You really shouldn't need any changes to DigitMaps in your case.
I fear your 123 is going out the LINE Port instead of SP1.
**1 123 would send it out SP1 if PrimaryLine is still at PSTN Line.
RonR:
If the problem is in fact that your PrimaryLine is set to PSTN Line and the 123 is going out the LINE Port, you have two choices:
1. Set PrimaryLine to SP1 Service so calls go out SP1 (Voipo) by default instead of the LINE Port and make calls out the LINE Port using **8 + number.
2. Leave PrimaryLine set to PSTN Line so calls go out the LINE Port by default and make calls though SP1 (Voipo) using **1 + number.
Keep the DigitMap I gave you, but you can remove the 123| rule:
(1xxxxxxxxxx|<1>[2-9]xxxxxxxxx|<1413>[2-9]xxxxxx|011xx.|xx.|(Mipd)|[^*]@@.)
jdubb7:
I changed the digit map back, however still can not call 123. I also tried **1123. If I pick up the phone wait for a dial tone then press **1 it begins to ring before I can finish dialing the 123.
RonR:
Are you sure the phone you're dialing from is connected to the PHONE Port on the OBi? And your landline is connected to the LINE Port on your OBi? It sounds like your telephone is conncted to your landline.
jdubb7:
Ok, If I use the phone connected to the Obi and dial **1123 I get the voice mail. Nice, thanks.
The Obi is also connected to a phone jack in the house and I have a phone plugged into another house phone jack. This is the phone that I was trying to call voice mail from.
Now that I've been messing around with this I noticed that I can make calls with this phone, but it does not ring when I call the house with my cell, only the phone plugged into the obi rings. I though that by plugging the obi into the house all the existing phone jacks work through the obi. Can I only make call and not receive them from the house or am I doing something wrong?
Navigation
[0] Message Index
[#] Next page
[*] Previous page