Help with Softphone Settings; Not working

<< < (2/2)

threehappypenguins:
Oh, by the way, if this helps any, this is what the Obi shows in the history when I try to call out from SP1 to SP3 from my Obion:

azrobert:
Quote

Basically, I want to be able to dial like I would straight from my home phone connected to my Obi. Right now I have everything set up so that 7 or 10 digits goes out of SP1, and and 11 digits goes out of SP3.

Voice Services -> ObiTalk Service -> InboundCallRoute
{(290xxxxxx)>(xxxxxxx|xxxxxxxxxx):SP1},{(290xxxxxx)>(xxxxxxxxxxx):SP3},{ph,ph2}

The above will route 7 and 10 digits to SP1 and 11 digits to SP3.
If 11 digits is 1 followed by 10 digits then change the rule to 1xxxxxxxxxx
Any other dialed number like zero will ring PH1 and PH2.

I don't understand your SP1 to SP3 test.
Does SP3 InboundCallRoute have any special rules?

threehappypenguins:
Okay, thanks, I will implement those rules when I get the chance.

I was trying to call SP1 to SP3 because I didn't want to call somebody else's number and bother them to test it. But I just did it anyway (called an outside number) just now and it works just fine. Oh well.

threehappypenguins:
I tried the rule you posted and it works perfectly for the 10 digit (SP1) dialing and 11 digit (SP3) dialing. But it doesn't work for the 7 digit dialing. It rings and rings, and then hangs up. I looked at the Obi history, and it says "Call Ended (603 Declined)."

P.S. - I assumed that for "290xxxxxx" in the rule that I'm supposed to put my Softphone number.

threehappypenguins:
Aha! Silly me. I should have seen that I needed to put the area code in the for 7 digit dialing. Like this:

{(290xxxxxx)>(<xxx>xxxxxxx|xxxxxxxxxx):SP1},{(290xxxxxx)>(xxxxxxxxxxx):SP3},{ph,ph2}

Where "xxx" is my (local) area code to fill in the gap.

Navigation

[0] Message Index

[*] Previous page