Using a different ougoing SIP provider with Callcentric
Shiblee:
I will use a OBi200 (1) SP1 as gateway. If I call from another OBi200 (2) how to ring at attached phone (of 1)?
azrobert:
The easiest way is to setup a Speed Dial like this:
pp(510111111)
Then dial the speed dial number.
Change 510111111 to the OBi number of OBi200#1
Shiblee:
Thanks...you reply quite quick...
However, I have two scenario here..
1. Calling through the OBi200 (1) SP1 directly from OBi200 (2).
2. Calling OBi200 (1) attached phone PH1 from OBi200 (2).
How to do it?
azrobert:
Do you have any outbound trunks on OBi200#2?
In other words, are you routing ALL outbound calls from OBi200#2 thru OBi200#1?
or
Are some outbound calls going out a trunk on OBi200#2?
It will make a difference how you dial the outbound number.
If you are routing calls out both OBi200s then you will need to dial a prefix to tell OBi200#2 to route the call to OBi200#1.
Are the numbers being dialed for the US?
If not what is the format (like number of digits)?
Shiblee:
It is in Asia, calls are 9-15 digit (Local/international excluding + or 00).
1. OBi200 (1) has a ip telephone connection (SP1) & attached phone PH1.
2. OBi200 (2) has only attached phone PH1.
#1. Make calls through OBi200 (1) SP1 directly from OBi200 (2) attached PH1 to phone network. I need also call to attached phone of Obi200 (1).
#2. All incoming calls at OBi200 (1) SP1 will be routed to OBi200 (2). I got answer,
Voice Services -> SP1 Services -> X_InboundCallRoute
The default is: ph >> Change it to: pp(OBI200 (2) NO)
Thanks.
Navigation
[0] Message Index
[#] Next page
[*] Previous page