how do I add PhonePower to OBI-100 when both SP1 and SP2 were used

<< < (2/2)

azrobert:
You can route calls from Callcentric to your OBi100 without it being registered.

Log into your Callcentric account.
Click on Call Treatments.
Click on Add a New Call Treatment.
Under "Redirect call to:" Click "This Number"
In the box enter: userid@xx.xx.xx.xx:5061
Leave all other settings at their default.
xx.xx.xx.xx is your public IP address.
userid can normally be anything.
If you are using the Oleg method to block scanners userid must match the name you are comparing for.
You might have to adjust the above if you are doing anything tricky with inbound routing.

In your router you must port forward the following ports to the IP address of the OBi100:
5061
16800 thru 16998

Test this setup without any other changes.
You might have audio problems when routing a call to the OBi like this with a URI address.

If this setup works then delete Callcentric from SP2 and define Phonepower.

pvpham:
Taoman:

Quote

Are you using a softphone on your cell phone that registers to your CC account?

No. I used the set up that azrobert shown and include the set up by jjjooonnn

http://www.obitalk.com/forum/index.php?topic=6862.0 (see Reply #2)

azrobert:

Thanks, You come to my rescue again  ;D. I try it tonight and report the result soon.

Navigation

[0] Message Index

[*] Previous page