Australian Configuration XML File

Started by MarkObihai, August 12, 2014, 02:29:17 AM

Previous topic - Next topic

MarkObihai

Attached to this post is the Australian XML settings file that can be uploaded to the OBi via the local user interface at:

System Management -> Device Update

At "Restore Configuration", select the xml file that is contained within the attached zip file.

Your OBi should now have Australian progress tones and dialled numbers will be processed quicker with the localised digit map.

If you are simply looking for an Australian digit map for your OBi device you can use the following:

(xxxx xxxx|0011xx.|0[1234578]xxxx xxxx|000|<112:000>|1800xxxxxx|180xxxx|1100|114x xxxx|119x|122x|1225|123x|124xx|125 xxx|1268x|1268 xxx|1268 xxx xxx|127x.|1282|128xxx|15x.|190xxxxxxx|1300xxxxxx|13xxxx|(Mipd)|xx.|[^*#]@@.)

Note that by default, "Ring Profile B" and "Tone Profile B" are configured for Australian ringing and progress tones.  Changing these settings for each service will make your OBi "sound" Australian.  
Obihai Technology (London, United Kingdom)

Toro

#1
I have purchased an OBi212 and have installed firmware 3-2-2-5921.fw.
The unit will be used in Australia.
Is the Australian Configuration XML file applicable to the OBi212 device?
If so, do any additional changes have to be made to the OBi212 settings to make it fully "Australian"?
Thank you for any assistance.

ploo

Quote from: MarkObihai on August 12, 2014, 02:29:17 AM
Attached to this post is the Australian XML settings file that can be uploaded to the OBi via the local user interface at:

System Management -> Device Update

At "Restore Configuration", select the xml file that is contained within the attached zip file.

Your OBi should now have Australian progress tones and dialled numbers will be processed quicker with the localised digit map.

If you are simply looking for an Australian digit map for your OBi device you can use the following:

(xxxx xxxx|0011xx.|0[1234578]xxxx xxxx|000|<112:000>|1800xxxxxx|180xxxx|1100|114x xxxx|119x|122x|1225|123x|124xx|125 xxx|1268x|1268 xxx|1268 xxx xxx|127x.|1282|128xxx|15x.|190xxxxxxx|1300xxxxxx|13xxxx|(Mipd)|xx.|[^*#]@@.)

Note that by default, "Ring Profile B" and "Tone Profile B" are configured for Australian ringing and progress tones.  Changing these settings for each service will make your OBi "sound" Australian.  

Hi MarkObihai

Thank you for the Australian Digimap xml file.  I restored the configuration after uploading the file to my OBI202.
How do I know if the xml file has been applied?  what should I check?
I also changed the Voice Services - SP1 Service to use ServProvProfile = B, RingProfile = B

I also prefer not to use OBITALK and the Auto Attendant but cannot Disable these services.
When I uncheck the Enable checkbox and rebooted, it automatically became Enabled again.