Google Voice Manual Config
revengineer:
Hi,
I am trying to setup Google Voice manually rather than through the Obitalk web site, but I am having no luck. I am setting as follows
ITSP Profile A/General set SignalingProtocol set to “Google Voice”;
ITSP Profile A/General set X_UseFixedDurationRFC2833DTMF to enabled (checked)
Voice Services/SP1 in the SIP Credentials section set AuthUserName to your Gmail email address (you may omit the “@gmail.com” if you wish);
Voice Services/SP1 in the SIP Credentials section set AuthPassword to your Gmail password;
Voice Services/SP1 in the Calling Features section set X_SkipCallScreening (way at the bottom) to enabled (checked). The need for this is explained fully in Step 8 below;
This was not working so I also tried
X_UserAgentPort 5080
OutboundProxyPort 0
ProxyServerPort 0
but no luck. When I configure through the Obitalk website everything works fine. I am using the latest firmware built 2868.
Help greatly appreciated.
gderf:
I don't think you can manually config for GV once the firmware has been upgraded to 4412. It uses a new authentication method with GV that isn't available in manual configuration settings.
azrobert:
Try to manually install build 2824.
Download here:
http://fw.obihai.com/OBi-1-3-0-2824.fw
Then go to:
System Management -> Device Update -> Firmware Update
I don't know if the Obi will let you downgrade.
mykmayk:
Quote from: azrobert on August 19, 2014, 10:30:18 pm
I don't know if the Obi will let you downgrade.
nope, i tried the other day. obi won't let me downgrade from 1.3.0 (Build: 2868) to 2824.
corporate_gadfly:
Quote from: gderf on August 19, 2014, 07:58:47 pm
I don't think you can manually config for GV once the firmware has been upgraded to 4412. It uses a new authentication method with GV that isn't available in manual configuration settings.
That's a big downer for me. I would like to use the Oauth 2.0 method for GV, but I am not willing to use the Obi portal. Am I out of luck?
What are the chances of switching to Obi portal for the GV setup briefly and then going back to manual config?
Navigation
[0] Message Index
[#] Next page