Localphone on VoiceGateway 3 not working

(1/4) > >>

atldiyer:
New guy here.  Been using my Obi100 for over a year now and I love it.  Works awesome.  Trying to do something more advanced and I am stuck:

SP1 is set up for Callcentric inbound calls and e911 outbound calls only.  Works awesome

SP2 is set up for Localphone outbound calls.  Works great.

Since Localphone is outbound only, I am trying to use Voice Gateway 3 to route outbound calls to localphone to free up SP2 for something else.

When I disable SP2 (leaving SP1 enabled) and enable VG3 (set correctly for Localphone), outbound calls are dialed correctly and even ring on the other end.  However, when the other party picks up the phone, there is silence - then a click - then the call is dropped.  The call is obviously originated correctly from the Obi, but somehow Localphone or the Obi drops the call.  Again, when using SP2 to make a call using localphone, it works flawlessly.

The Obi's Call History shows the call was routed over VG3 correctly. 

Thanks in advance

drgeoff:
I have LocalPhone on a VoiceGateway on my OBi110 working fine.  I'm in the UK but doubt that would make any difference.

I know this does not help you much other than letting you know that you are not trying to do something  which will never work.

azrobert:
Did you resolve your problem with VG3?

There is another way to accomplish what you want.
I don't want to spend the time explaining if you already fixed the problem.

Edit:
If the problem is not resolved:
Which provider were you planning to use on SP2?

atldiyer:
I never got it working and just went back to the way I had it.

Now, with GV being supported, it would be nice to have LocalPhone on VG3 if I could just get it working.

SP1- GoogleVoice for domestic US calls (incoming and outgoing)
SP2- CallCentric for e911 and inbound/outbound faxes
VG3- Localphone for a backup to GV domestic US outbound calls

Thats what I would like to do.  Sounds like I need to do a firmware update to get Google Voice back, so I'll play with Localphone on the VG once I do that.

Thanks,

Mike

azrobert:
Are you getting any error messages when you route a call to localphone on VG3?

You said "I disabled SP2".
What did you do to disable it?
You can't point a VG at a SP trunk that has been disabled.
I don't think you did this because the call would fail and not show in the call history.
Did you define VG3 AccessNumber like this: sp2(localphone.com)
Please post what shows in the call history.

Try defining Callcentric on VG3 and see if an outbound call works.  I know Callcentric works on a VG. If it works you are defining the VG correctly.

If you determine Localphone must be defined on SP2, you can setup Callcentric on VG3 even if you receive inbound calls. Your setup would be:
SP1- GoogleVoice for domestic US calls (incoming and outgoing)
SP2- Localphone for a backup to GV domestic US outbound calls
VG3- CallCentric for e911 and outbound faxes
CallCentric inbound faxes direct to the OBi100.

See: http://www.obitalk.com/forum/index.php?topic=8397.msg55159#msg55159

Navigation

[0] Message Index

[#] Next page