Does any one know how to get one cell phone to ring on 3 OBi1032s?
Boykin:
I have 3 OBi1032s. I have one set up with an OBi Bluetooth adapter with my cell phone paired to it. I would like this OBi1032 to ring the other 2 OBi1032s when a call comes in on my cell phone. Does any one know how to do this? If so, can you give me detailed instructions?
If possible, it needs to work with IP addresses over my LAN. The only internet I can get where I live is satellite internet and there would be a lot of lag if the call has to go out to the internet and then back to my LAN.
azrobert:
I don't own an OBI1032, but it should work the same as an OBI ATA.
OBiBlueTooth -> InboundCallRoute:
{ph,anything@192.168.1.101:5060,anything@192.168.1.102:5060}
Here is a demo page for the OBi1032.
I don't see where OBiBlueTooth is defined.
http://www.obihai.com/uidemos/obiphone/i
Boykin:
Quote from: azrobert on August 28, 2014, 07:41:53 am
I don't own an OBI1032, but it should work the same as an OBI ATA.
OBiBlueTooth -> InboundCallRoute:
{ph,anything@192.168.1.101:5060,anything@192.168.1.102:5060}
Here is a demo page for the OBi1032.
I don't see where OBiBlueTooth is defined.
http://www.obihai.com/uidemos/obiphone/i
Do I have to set anything up on the 2 OBi1032s that don't have the BT device attached?
azrobert:
I forgot about the other devices.
Port 5060 points to SP1.
If SP1 on the other device is defined as SIP then you don't have to do anything.
If it's not defined, this is how to define a dummy trunk:
Service Providers -> ITSP Profile A -> SIP -> ProxyServer: 127.0.0.1
Voice Services -> SP1 Service -> AuthUserName: (any userid)
Voice Services -> SP1 Service -> X_RegisterEnable: (unchecked)
If SP1 is defined as GoogleVoice then use port 5061 for SP2.
Define SP2 like this:
Service Providers -> ITSP Profile B -> SIP -> ProxyServer: 127.0.0.1
Voice Services -> SP2 Service -> AuthUserName: (any userid)
Voice Services -> SP2 Service -> X_RegisterEnable: (unchecked)
And this:
Voice Services -> SP2 Service -> X_ServProvProfile: B
CLTGreg:
Can something like this be done to mix the 1032 with a 202? I assume so but I don't have a 1032 yet but I'd like one.
What I'd like to do is have the 1032 handle multiple lines and trunk out the ones I want to ring in the house. The 202 would handle ringing the house wiring so it appears on all my phones. I guess this could be done with all the lines but I don't want to be woke up by some of them ;D
Navigation
[0] Message Index
[#] Next page