Does any one know how to get one cell phone to ring on 3 OBi1032s?
azrobert:
I forgot to pass CallerID.
OBiBlueTooth -> InboundCallRoute:
{ph,sp1(anything@192.168.1.101:5060;ui=$1),sp1(anything@192.168.1.102:5060;ui=$1)}
Boykin:
I made that change. It works. Thanks.
The lag is so bad with a microcell that I think doubling the trips up to the sat would make the call very lagged.
Boykin:
Is there a way to be able to pick up one of the 1032s that does not have the BT adapter and make a call using the cell phone? I can on the 1032 with the BT adapter, but not the ones without the adapter.
Not sure if this is possible or not.
azrobert:
Non-BT OBi1032
Change the current dummy trunk to:
Service Providers -> ITSP Profile C -> General -> DigitMap:
(1xxxxxxxxxx|[2-9]xxxxxxxxx|xxxxxxx)
(or your requirements for BT)
Service Providers -> ITSP Profile C -> SIP -> ProxyServer: 192.168.1.32
(IP addr of BT-OBi1032)
Service Providers -> ITSP Profile C -> SIP -> RegistrarServerPort: 5062
(Port# of SP3 on BT-OBi1032)
Voice Services -> SP3 Service -> AuthUserName: OBi1032
Voice Services -> SP3 Service -> X_RegisterEnable: (unchecked)
Voice Services -> SP3 Service -> X_ServProvProfile: C
BT OBi1032
Change the inbound route on current dummy trunk to:
Voice Services -> SP3 Service -> X_InboundCallRoute: {OBi1032>(xx.):bt},{ph}
On the Non-BT OBi1032 dial **3 followed by the outbound number
Boykin:
Thanks. I will give this a try when I get home.
Navigation
[0] Message Index
[#] Next page
[*] Previous page