Does any one know how to get one cell phone to ring on 3 OBi1032s?
Boykin:
Thanks. I did not factory reset the 202. I just made the modifications necessary to get what we talked about working. I was going to use the 202 so I would not have to redo everything else, but I have scrapped that plan. I have factory reset, deleted from ObiTalk and added all of my 1032s back. I am going to use one of them as the main and have the BT and SIP lines on it and have everything forwarded to the other 2 using the directions you have given me.
I made the decision to scrap the 202s for now when I started experimenting with disabling codecs on the 202. The 1032s would ring but you could not answer or make calls from them. I completely hosed codec profile A. I put everything back the way it was but it still did not work. I changed to B and everything worked again. Once I get all my settings off of the 202s, I will delete them from OBITalk and factory reset them to get rid of OBiPlus. I think I going to put the 202s in storage until I need them for something else.
Thanks for all your help.
Boykin:
Another question.
Does anyone have any idea why a SIP line from a local telco can be set up on a 202 using the wizard and work fine, but does not on a 1032. I can receive calls on the 1032, but I cannot call out. The SIP line will say registered on the 1032. I only had the SIP line on one device at a time in case there was a conflict.
azrobert:
Did you check the call history to see that the call is routed to the correct trunk? What happens, any error message or code?
Navigation
[0] Message Index
[*] Previous page