Using Second OBi100 At Second Home

<< < (2/3) > >>

hwittenb:
You can setup the primary OBi to ring both the home phone and the second OBi on an incoming call.  You can do this by modifying the primary OBi's X_InboundCallRoute.  You can send the call over the OBiTalk network to the second OBi.

azrobert:
Does Vestalink mean setting up a sub-account under your main account or a totally new account with a different phone number? If it's possible, a sub-account is the way to go. You would have 2 extensions for the same phone number. I'm not familiar with Vestalink, so I don't know if this can be done.

The following is how to use OBi100#1 and the OBiTalk network to make and receive calls from OBi100#2.

In OBi100#2
Physical Interfaces -> Phone Port
Add the following to the beginning of the OutboundCallRoute:
{(<200111111*>(Msp1)):pp},

200111111 is the OBi number of OBi100#1
This will route outbound calls from OBi100#2 to OBi100#1 using the OBiTalk network.


In OBi100#1
Voice Services -> OBiTalk Service
Add the following to the beginning of the InboundCallRoute:
{200222222>(Msp1):sp1},

200222222 is the OBi number of OBi100#2
This will bridge outbound calls from OBi100#2 to SP1


Voice Services -> SP1 Service -> X_InboundCallRoute
The default is: ph
Replace it with: {ph,pp(200222222)}

200222222 is the OBi number of OBi100#2
This will route inbound calls on SP1 to the Phone Port and OBi100#2.

Disclaimer: I did not test any of the above, so there might be errors.


 

Ismellelephant:
Thanks for all the suggestions. I am thinking of putting the same Vestalink config details into both OBis. If I do a backup of my primary OBi100 then do a restore onto the second OBi100 will that work?

Ismellelephant:
And yes Vestalink said to open total new account with a new number, I don't see a sub account option at all.

Taoman:
Quote from: Ismellelephant on August 29, 2014, 09:19:34 am

And yes Vestalink said to open total new account with a new number, I don't see a sub account option at all.


Based on your OP you don't need a new account or a new number. Vestalink does not support sub accounts but they do support multiple simultaneous UAs registered to your account.

You don't need to use the same ip address, you need to use the same SIP credentials. You should be able to set up your second Obi the same way you have the first one configured.

Disclaimer: At least that's the way things worked at Vestalink when I was a subscriber a few months ago. Things may have changed since then.

Navigation

[0] Message Index

[#] Next page

[*] Previous page