OBI110 not working after firmware update
kingkong:
I just installed OBI110, logged in to obitalk.com and added the device, I was able to call normally and access the obi110 web page, and then I download the obi-1-3-0-2824.fw firmware and chose update, everything start to fail from here.
The device couldn't communicate with the router and unable to obtain an ip, the power led keep flashing, I changed another lan cable and change another router port, led just keep flashing.
I tried to add device from obitalk, entered the xx5 xxxx code, I got the automated response but the device is never detected. I pushed the little hole under obi110to reset it and also restarted my router, led keep flashing and nothing works. I couldn't access the obi110 web page anymore, what can I do now?
Taoman:
You may wish to download and install the latest version of the firmware:
http://fw.obihai.com/OBi110-1-3-0-2872.fw
kingkong:
I couldn't access the obi110 webpage at all. I called xxx0 and then 1# it tells me my firmware is already 1.3.0.2872
Taoman:
Quote from: kingkong on September 08, 2014, 06:36:49 am
I couldn't access the obi110 web page anymore, what can I do now?
You could try the following:
1. Disconnect OBi from router
2. Remove power from OBi.
3. Using a paper-clip, depress and hold the reset switch accessible through the bottom of the unit.
4. Reconnect power to OBi.
5. Continue holding the reset button depressed for at least 30 seconds.
The unit should now be reset to factory defaults.
6. Reconnect OBi to router.
kingkong:
Still not working, I also rebooted the router again...LED still flashing green light. I called ***1 it says ip not available, dhcp enabled.
Navigation
[0] Message Index
[#] Next page