OBI110 not working after firmware update

<< < (4/4)

kingkong:
all right I tried everything I can but it still keeps blinking, I talked to my local merchant and he exchanged another one, now everything is working normal again.  :)

Thx you all for the support. If you also have OBI110, I don't recommend you update firmware OBi-1-3-0-2824.fw found in this page
http://www.obitalk.com/forum/index.php?topic=9.0

RFC3261:
Quote from: kingkong on September 10, 2014, 07:24:29 am

I don't recommend you update firmware OBi-1-3-0-2824.fw found in this page
http://www.obitalk.com/forum/index.php?topic=9.0


I have upgraded without issue.  Perhaps I was lucky.  Or perhaps you were unlucky.  Hardware failures happen.  And firmware updates do do things like (re)writing flash memory, which if it was near failure (or lacked sufficient number of spare blocks), may push it over the edge.  Or if the power supply was weak, a reboot that asks for (greater than run time) power may result in inability to reboot (seen that with lots of devices, not just the Obi).  And a major router vendor announced at the beginning of the year a failure mode due to bad OEM memory such that any power cycle might result in failure.  Hardware failures happen.  You just have to have appropriate plans in place to deal with failures.

mykmayk:
i have all my 3 obi1x's running OBi-1-3-0-2824.fw with no problem -- neither during their update nor their daily use.  lucky me, too  ;D

Navigation

[0] Message Index

[*] Previous page