OBI110 not working after firmware update
Taoman:
Quote from: kingkong on September 08, 2014, 08:03:08 am
Still not working, I also rebooted the router again...LED still flashing green light. I called ***1 it says ip not available, dhcp enabled.
Is this a newly purchased device? Unless someone has a better idea I would open a trouble ticket with Obihai.
I would also disconnect OBi from power for an extended period of time (day or two) if possible.
kingkong:
I bought it 5 days ago. It works fine before I update firmware OBi-1-3-0-2824.fw... :'(
the light on the router port is on, it is the same port I used earlier when everything works...so I don't think the router is faulty.
cluckercreek:
When you did the "hard reset" with the paper clip, did you watch the light pattern that was flashing? You have to hold it till it it turns solid red then release.
Taoman:
Quote from: kingkong on September 08, 2014, 08:21:08 am
I bought it 5 days ago. It works fine before I update firmware OBi-1-3-0-2824.fw... :'
So you've only applied version 2824 but it's reporting that it's at version 2872? Did you add Google Voice as a service provider? That probably would have triggered an automatic upgrade to 2872.
It's a long shot but you could force your OBi's ethernet port to 100mb full-duplex. You could also set a static ip address for your OBi if you haven't already done so.
The following procedure will change the OBi Ethernet port from 10 mb/s half-duplex to 100 mb/s full-duplex:
1. Dial *** 0
2. Enter option 27 and press #
3. Press 1 to set a new value
4. Enter a value of 1 and press #
5. Press 1 to confirm/save
6. Hang up
7. Wait for the OBi to reboot
kingkong:
yes I wait until it turned red, restart power, but it just keep flashing green light. I also tried ***8 to restore factory default, still not working.
Navigation
[0] Message Index
[#] Next page
[*] Previous page