Obi110 - Phone Line CallerID not passed to Asterisk
azrobert:
I don't think the definition details are important.
The host=IP_Address must match the OBi110's IP address.
Port number must be 5061 if you are using SP2 to route the call to Asterisk.
Port number must be 5060 if you are using SP1 to route the call to Asterisk.
The port numbers above assumes you haven't change the OBi110's default X_UserAgentPort.
Like I said in a previous post when I test and these don't match the call is rejected with error 403 forbidden.
bravo2:
With FreePBX trunk configuration as described above helped me pass the authentication error. Now LINE Port InboundCallRoute value SP2(1234567890@192.168.1.5:5060;ui=2223334444) is giving 2223334444 as caller id. This is good progress.
But SP2(2242120185@192.168.1.5:5060;ui=$1) is giving caller id as backquote (`). I have no idea why $1 is not expanded to incoming caller id. I am going through OBi110 administration guide, but have not found anything wrong with my setup yet. I will keep trying.
thanks very much for your help so far.
azrobert:
If you plug a phone directly into the wall jack do you get callerid?
Check the OBi110 call history.
Log directly into the OBi110 using the Web interface.
Using an internet browser enter the IP address of the OBi110 and hit Enter.
If you didn't change them the default userid and password are both "admin".
On the left column click Status then click Call History.
Peer Number should show the callerid.
Is it correct?
bravo2:
I just tested it and callerid not showing up on the phone connected to OBi110 phone port. Phones directly connected to PSTN line shows callerid.
I decided to start from scratch instead of debugging what I have. I have just factory reset; I am going through the setup. I will soon post updates here.
Thanks
azrobert:
In the U.S. callerid from PSTN is transmitted between the 1st and 2nd ring. RingDelay on the Line Port definition delays the call processing to give the OBi110 enough time to receive CallerID. The 4 second default should be more than enough time, but you could try a value of 6000.
Navigation
[0] Message Index
[#] Next page
[*] Previous page