How do I set up Obi110 to use the POTS as default outgoing?

(1/2) > >>

IgorB:
Hi Everyone!

I spent days trying to figure this out on the forums and web, to no avail.  ??? I assume it is very simple.

Now if I make a call using my phone plugged into the Obi110, it uses my GV account. If I want to use the POTS line, I can dial **8 or # and wait for a dial tone. Firstly, how can I change it so the default is POTS? Also, If someone is on another POTS extension, I can not get into the line using **8 or #. Is there anything I can do? I tried dialing *76 (?) for barge-in, is that right? I did not succeed in getting in.

I see in the Obi IP web page setup, Voice Services>Auto Attendant>Auto Attendant 1> Outbound Call Route>says {([1-9]x?*(Mpli)):pp},{0:ph},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}
and the next line shows Primary Line>PSTN.
Should I change things there?

Thanks in advance!  ;D
Igor

azrobert:
Physical Interfaces -> Phone Port -> Primary Line: PSTN Line

If you want the Auto Attendant to default to the Line Port leave it unchanged.

For Barge In See: http://www.obitalk.com/forum/index.php?topic=7761.0

I can't get my OBi110 Barge In to work.

IgorB:
Quote from: azrobert on September 16, 2014, 08:23:21 am

Physical Interfaces -> Phone Port -> Primary Line: PSTN Line

If you want the Auto Attendant to default to the Line Port leave it unchanged.

For Barge In See: http://www.obitalk.com/forum/index.php?topic=7761.0

I can't get my OBi110 Barge In to work.



Thanks azrobert, that is how it is now. ?? I will try to change it, reboot and set it back, will update.

IgorB:
It did not help - changing and resetting. Now I tried disabling the auto-provisioning because I saw that after reboot, it did not stay changed. Now I changed to SP1, saved, reboot, changed to PTSN, saved, reboot. Still not working; still default outgoing is GV instead of telco/pots line.  :-\ :(

Is there anything else to try?

IgorB:
Thanks azrobert,

I read your point in the thread with Daniel, that when I pick up the phone connected with obi110, I get an obi dial tone, then when I press # I get the POTS dial tone. That was throwing me off, I assumed the default outgoing would work straight up. Anyways, now it is working as you say, the default outgoing is POTS. Thanks so much!  8) :)

It does take a bit of time to connect, what can I try to make the call go through faster? (I think when I press # first, it takes faster.

TIA!

Navigation

[0] Message Index

[#] Next page