How do I set up Obi110 to use the POTS as default outgoing?

<< < (2/2)

MurrayB:
If after receiving the Obi dial tone you enter the number and then depress # the Obi recognizes this as the end of the number and sends the call on it's way. I believe that this works with any SP setting.

If you depress # immediately upon getting the Obi dial tone the unit will return a POTS dial tone and then you dial.

So with POTS as your default setting you could go either way. Also with POTS as your default setting appending the telephone numbers with # in your speed dial list means you do not need to do anything but pick up the phone and select your speed dial. The obi sees the # at the end and sends the call on it's way.

Good Luck!

azrobert:
This is the default Line Port digitMap:
(xxxxxxxS4|1xxxxxxxxxx|xx.)

xx. will match any number of dialed digits and is the cause of the delay.

xxxxxxxS4 the S4 will force a 4 second delay for 7 digits

1xxxxxxxxxx will pause for 3 seconds because the OBi110 doesn't know if you will dial additional digits because of the xx.

xx. if the dialed number only matches this it will pause for 10 seconds.

If you use DigitMap:
(xxxxxxx|1xxxxxxxxxx|[2-9]xxxxxxxxx)

7 digits will pause for 3 seconds
10-11 digits will be immediately routed

Navigation

[0] Message Index

[*] Previous page