Send incoming calls straight to a busy signal? Disable voicemail on 110
azrobert:
You have CallForwardUnconditionalEnable checked and no forwarding number.
It probably isn't doing anything because your phone is still ringing.
It should be unchecked.
If you are still getting Call Waiting tone remove all the forwarding settings and just have the following:
Physical Interfaces -> Phone Port -> CallWaitingEnable: Unchecked
If you still get the Call Waiting tone I have no idea what to do.
Donnyten:
I'm losing my mind.
I uncheck callwaitingenable, and the system management provisioning setting that I set to disable somehow sets itself back to " periodically". If i do it in reverse order the same thing Happens.I have no idea whats going on
azrobert:
Are you sure you're changing OBiTalk Provisioning to Disabled and not ITSP Provisioning?
Donnyten:
Yes.
I've the call waiting disabled but the problem is it still goes to my voicemail after 26 seconds.
azrobert:
Call forward on busy doesn't work for GoogleVoice.
See: http://www.obitalk.com/forum/index.php?topic=5262.msg34181#msg34181
That was almost 2 years ago. A lot of my brain cells have died since then and I forgot about this. Sorry!
I think if you get a 2nd DID and define it on your OBi. Then have GV route calls to both DIDs. Call forward on busy should work on the 2nd DID. I think IPComms still has free DIDs.
I will setup this config on my OBi/GV and report back later.
Navigation
[0] Message Index
[#] Next page
[*] Previous page