Send incoming calls straight to a busy signal? Disable voicemail on 110
azrobert:
Quote from: SteveInWA on September 18, 2014, 07:55:14 pm
remove that spaghetti-pile of settings you may have added.
I disagree with your characterization of what I did. I must admit it took me 2 1/2 approaches to get this to work, but the final solution is 1 line of code in the OBi and a 4 line Tropo script. There is an additional 4 changes in the OBi to setup a dummy trunk only needed because the OP doesn't have a SIP trunk defined.
This is what you call "spaghetti-pile of settings":
Voice Services -> SP1 Service -> X_InboundCallRoute:
{ph,sp2(9990012345@sip.tropo.com)}
This solution worked for me. The true test is if the OP can get it to work.
Donnyten:
I thank the both of you for the help I have received so far.
I tried the call centric method and I'm able to call myself, but when I tried to call that same line from another phone all the phone does is ring. Can I set it up so that incoming calls go straight to a busy signal?
I've lost about 4 hours of sleep trying to get a dang busy signal to the point when I now have a headache and have to go back to work in an hour or two
SteveInWA:
Hi Donny:
I sent you a private message with the additional setting you probably need to change on the Callcentric portal page to send calls to the busy signal, and some related information. It's been so long since I set up a clean/new CC DID, that I can't recall all their default settings.
Donnyten:
Thanks for the correspondence.
It works now, the issue was that google doesnt support " early media" which would explain why I always heard rangs when I dialed the CC number. But i tried again with another it it works without a problem. :-)
Thanks so much guys :)
SteveInWA:
Quote from: Donnyten on September 19, 2014, 05:27:51 pm
Thanks for the correspondence.
It works now, the issue was that google doesnt support " early media" which would explain why I always heard rangs when I dialed the CC number. But i tried again with another it it works without a problem. :-)
Thanks so much guys :)
Yay! Glad you got it to work. Enjoy the cost savings.
Navigation
[0] Message Index
[*] Previous page