Obi202 rings *only* on phone 1 with two GV SPS configured for PH1 and PH2

(1/2) > >>

Vincent:
Configuration is fairly straight forward:

SP1 - GV is set to ring on "phone 1" (as well as outgoing)
SP2 - GV is set to ring on "phone 2" (as well as outgoing)

I can make outgoing calls from phone 2 (line 1) which correctly shows GV phone number for SP2, however, incoming will ONLY ring on the second pair of wires for (aka line 2) of phone 1.

Phone 1, line 1, works as expected.

I'm using the basic configurator on the website, however when I go to advanced mode it *appears* the settings are set correctly.

Any ideas?

Vincent:
Not sure if this has anything to do with anything but my OutboundCallRoute for "phone 2" has this configuration. Note the ph1.

{([1-9]x?*(Mpli)):pp},{(<##:>):li},{(<#:>):ph1},{(<**70:>(Mli)):li},{(<**82:>(Mbt2)):bt2},{(<**81:>(Mbt)):bt},{(<**8:>(Mbt)):bt},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**3:>(Msp3)):sp3},{(<**4:>(Msp4)):sp4},{(<**9:>(Mpp)):pp},{(Mpli):pli}

OutboundCallRoute for "phone 1" has this configuration:
{([1-9]x?*(Mpli)):pp},{(<##:>):li},{(<#:>):ph2},{(<**70:>(Mli)):li},{(<**82:>(Mbt2)):bt2},{(<**81:>(Mbt)):bt},{(<**8:>(Mbt)):bt},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**3:>(Msp3)):sp3},{(<**4:>(Msp4)):sp4},{(<**9:>(Mpp)):pp},{(Mpli):pli}

azrobert:
Dialing # from phone 2 will ring Phone 1 using this rule {(<#:>):ph1}
Dialing # from phone 1 will ring Phone 2 using this rule {(<#:>):ph2}

The inbound routes determine which phone rings.

Voice Services -> SP1 Service -> X_InboundCallRoute should have a rule ph
Voice Services -> SP2 Service -> X_InboundCallRoute should have a rule ph2

Vincent:
I have {ph1} for SP1 as the X_InboundCallRoute and {ph2} for SP2 according to the expert config however calling from an 3rd phone (mobile) to SP2 rings only on "line 2" (blue and yellow wires) of "phone 1" port. It will not ring on red and green wires of "phone 2" port. I have not tried the yellow and blue wires (line 2) of phone 2 port.

Any ideas?

azrobert:
I don't own an OBi202, so I might have a misunderstanding.

I thought the 2 outside contacts on Phone Port#1 were hard wired to the 2 inside contacts of Phone Port#2. There are no configuration settings that controls this. If a call rings the outside contacts on Port#1 and not the inside contacts on Port#2, I think you have a faulty unit.

I also think the 2 outside contacts on Port#2 are dead. Maybe they switched wires when your unit was built.

Navigation

[0] Message Index

[#] Next page