Obi Blue Tooth Adapter Settings Question

[kamhighway]

I have an Obi 200 and purchased the Obi blue tooth adapter so I can make my cellphone be the default for outbound calls. In the settings, there is a box to input an area code.  If I put 650 into the box, then dial 650 948 1XXX from the phone handset, the number that the cellphone dials is 650 650 9481 -- which is not what I want.  If I dial 948 1XXX, then the cellphone correctly dials the number. However, if I dial a number in a different area code say 808 373 3XXX, the cellphone dials 1 650 808 3733.  I have to dial 1 808 373 3XXX to get the cellphone to dial the correct number.

If i leave the area code in the settings blank, I find that I have to dial 11 digits for every number in order for the cellphone to dial correctly.  Is this the expected behavior?  Are there any other settings that I am missing that will make it easy to dial 7 digits when the call is to the same area code, and 10 digits when it the call is within the U.S. and outside of my area code?

Thanks in advance.

[azrobert]

I believe you need to manually configure the BT settings.

Enter OBi Expert
Click On Voice Services -> OBiBlueTooth 1
On the right of DigitMap uncheck OBiTalk Setting then uncheck Device Default.
DigitMap: (1xxxxxxxxxx|[2-9]xxxxxxxxx|xxxxxxx)
Click Submit

Now 7, 10 and 11 digit numbers will be sent as dialed.

[kamhighway]

@azrobert

Thank you for sharing your expertise.  I started reading the documentation and found it hard to follow. I was about to request an RMA from Amazon when I saw your post.

I've made the change and it seems to working now.

Thanks again.