OBI-110 set up for local service
salimashah:
My Setup: Obi-110
Wired phone service with a phone number (Home #)I would like to keep and not port it over.
Local phone service. (LS)
Google Voice. I have an assigned number (GV #)
Currently (default setup). Incoming (Home #) is being routed to phone correctly
All outgoing seem to be routed through GV. Destination gets caller id of (GV #)
Desired setup:
I would like to make local calls (non-toll) to use LS and not GV
I would like 911 and 311 (essentially any 3 digit) outgoing to use LS not to go through GV
Long distance to use GV and not LS. (this is working)
Stretch goal: Can I have the long distance (through GV) show my caller ID of my Home #. Little that I know says (spoofing?) is not possible with GV. If so, this is not a biggie.
A while back I had a cheat sheet to setup the Obi-110 but since GV support was removed, I did not track it.
Now GV is available and I would like to pursue this.
Another request, I am a newbie so please avoid loaded technical terms.
Salim.
azrobert:
Some providers allow spoofing. GV is not one of them.
Are you familiar with using OBi Expert to configure your OBi110?
What are your non-toll numbers.
I assume 7 digit and 1800xxxxxxx numbers.
What about 10 digit numbers?
11 digits with specific area codes?
salimashah:
Thank you for a prompt reply
GV -- no spoofing --fine I can live with it.
Expert Configuration -- I think I can get to the panel.
non toll would be 512-xxx-xxxx, 1-800-xxx-xxxx, 1-888-xxx-xxxx
toll would be 1-512-xxx-xxxx (eleven digit, except 800/888).
If you give me the rope ;D, I can hopefully figure out any combination that I forgot.
Thanks
azrobert:
The following is how to use OBi Expert.
I already had this written.
I'll be back with the rest in a few minutes.
From the OBiTalk dashboard click Edit Profile on the left column.
At the bottom of the page check "Enable Obi Expert..."
Click Submit Query.
Click Obi Dashboard.
On the right of your OBi110 is an icon with a red E.
Click on it to enter OBi Expert.
To navigate click on the titles with the +
Then click on a sub-title
An example click on Service Providers
Then click ITSP Profile A General
To change a setting uncheck the box under ObiTalk Setting
Then uncheck the box under Device Default
Now change the setting
After you make all the necessary changes for that page then click Submit at the bottom of the page.
OBiTalk will download the configuration changes to the OBi110 and reboot it.
Wait until this process is complete before continuing to the next page.
azrobert:
Service Providers -> ITSP Profile A General -> DigitMap:
(1xxxxxxxxxx|011xx.)
Physical Interfaces -> Phone Port -> DigitMap
Add AFTER the beginning parenthesis: (Mli)|
It will look like this:
((Mli)|.....the current settings....)
Physical Interfaces -> Phone Port -> OutboundCallRoute
Add to the beginning: {(Mli):li},
Physical Interfaces -> Phone Port -> Primary Line: SP1 Service
Physical Interfaces -> Line Port -> DigitMap
(xxx|[2-9]xxxxxxxxx|18(00|88|77|66|55|44)xxxxxxx)
11 digit and international numbers will be routed out SP1
3, 10 and tollfree numbers routed out Line.
Navigation
[0] Message Index
[#] Next page