OBI-110 set up for local service

<< < (6/6)

salimashah:
"confused" ... you are  being kind here azrobert.

It really is lack of understanding :)

DigitMap without variable is easy to understand, but the  RouteControl is not well understood by me.

Thanks again.

Salim

azrobert:
I made an error with my last post.
The following will not work and was removed from that post:
OR
Remove {(<#:>|911):li} and add # to the DigitMap like this:
Physical Interfaces -> Line Port -> DigitMap
(#|xxx|[2-9]xxxxxxxxx|18(00|88|77|66|55|44)xxxxxxx)

Edit:
It seems I'm the one confused.
I also made an error with this:
"If you want change it to {(<#:>:li}"

I changed it to"
"If you want change it to {(<#:>):li}"

salimashah:
I am back with setup questions related to security panel.

1. How I do I pass '#' to the line port (telco side) and then allow communication (any key from phone and voice from the line to the phone).

2. How do I allow AutoAttendent to prevent "#" to be sent to the line (telco side).


Salim

azrobert:
{(<#:>):li} in the Phone Port OutboundCallRoute will remove "#" from the dialed number. It's like you didn't dial anything, so you just get Dial Tone.

Change the rule to {#:li} and now the "#" will be sent out the line port. After that the OBi110 will not be in control and you will be able to dial anything.

The Auto Attendant has its own OutboundCallRoute that doesn't include this rule, so you don't have to worry.

I don't think you are using the Auto Attendant, so just disable it.

Voice Services -> Auto Attendant -> Enable: Unchecked

salimashah:
I have made the setting.

Will test it out and post back.

Thank you azrobert.

If any obi110 user want me to share my settings, I can post them here.

Salim

Navigation

[0] Message Index

[*] Previous page