Always enable "modem mode" ..?

<< < (2/3) > >>

Mango:
Please set up the following as a star code on your OBi200.  Note that even though it is called a star code, there is no * present:

16042999000,Modem Call,set($Noji1,200),set($Noec1,1),set($Cdm1,3),call(16042999000)

Replace both instances of 16042999000 with the actual number that your device dials, in the exact same format, which you will find in the OBi's Call History.  Let me know if it works.  I don't have an OBi2 device so am limited by how much I can test.

With this scenario, a pause should not be required.

n808:
Awesome, that sounds like it might work, at least to get the options enabled. I will try when I get home.

azrobert:
See the update in my last post.

n808:
@azrobert : I will try Mango's suggestion, as I cannot program or change the device's phone numbers. It does not dial too fast for the OBi, it's just too fast for the 1st attempt at a semi-star code which requires a pause for the OBi to absorb the first part of the number, and provide a new dial tone, before the last four digits.

In Mango's suggestion, the entire number is absorbed as a *-code, hopefully - then as you both suggested, instructs the OBi to call the same number. I was not aware of this possibility.

n808:
It works! First attempt - the call went a little longer than usual I assume it negotiated a lower speed, but it worked flawlessly. I verified during the call that jitter buffer was at 200ms, so the settings had been applied.

Good-bye POTS (or expensive Comcast VoIP in my case - I still call it POTS) :)

Thank you for the help!

Navigation

[0] Message Index

[#] Next page

[*] Previous page