connecting OBi110s to legacy PBX analog Ports Via OBi110s line ports
QBZappy:
Quote from: Motohead on October 02, 2014, 03:19:00 pm
Wile I'm on the subject does anyone have any recommendations for a cordless (WiFi) sip phone ?
Any cheap second hand android device should work as a wifi phone. You can pick up a used phone just about anywhere.
Motohead:
I'm not familiar with android is their a better model (wifi wise) to look for?
Motohead:
Quote from: azrobert on October 04, 2014, 08:23:14 pm
After the Line DigitMap change you can also use the following for the ITSP A inbound route:
{iPhone1>(Mli):li}
Will this change allow for inbound station to station calls to the iPhone?
looking under Service Providers>ITSPProfileA>SIP I don't see an inbound route field
drgeoff:
Quote from: Motohead on October 07, 2014, 05:47:02 am
Quote from: azrobert on October 04, 2014, 08:23:14 pm
After the Line DigitMap change you can also use the following for the ITSP A inbound route:
{iPhone1>(Mli):li}
Will this change allow for inbound station to station calls to the iPhone?
looking under Service Providers>ITSPProfileA>SIP I don't see an inbound route field
You are looking in the wrong place.
Try Voice Services/SPx Service/SPx Service/X_InboundCallRoute where x is the relevant number between 1 and 4.
Motohead:
so I'm modifying the same lines as before?
i have
{iPhone1>(9|xxx):li} (This works OK but you have to wait for outside dial tone then dial the number)
I added
{iPhone1>(9|xxxlMli):li}
I can still get an outside line but cant dial internally the groundwire app shows Busy and the iPhone still wont receive internal calls
I know I'm close to getting this with all you folks help !
Navigation
[0] Message Index
[#] Next page
[*] Previous page