connecting OBi110s to legacy PBX analog Ports Via OBi110s line ports

<< < (6/7) > >>

azrobert:
Physical Interfaces -> Line Port -> DigitMap: (9|xxx|9xxxxxxx)

Then use:
{iPhone1>(Mli):li}

(Mli) refers to the Line DigitMap
Use this method to avoid defining the DigitMap in 2 places.

The above will allow these dialing patterns:
1) Dial 9
You will get dial tone from the PBX then dial 5551212
2) Dial 95551212
There will be no pause after the "9"
Will the PBX function properly with no pause?

If you need a pause do this:
Physical Interfaces -> Line Port -> DigitMap: (9|xxx|9<,,,,,>xxxxxxx|9,,,,,xxxxxxx)
<,,,,,> will insert 5 commas after the "9".
Each comma is a .2 second pause.

I never did the above. Hopefully I did it correctly.

ianobi:
I have used pauses and it all looks fine.

It seems to me that this problem is being overcomplicated, unless I have missed something. It seems that the OP would like the OBi110 to operate just as a desk phone connected to the PBX. How about an InboundCallRoute of

{iPhone1:li}

Any digits received will simply be routed through to the PBX

azrobert:
Quote from: ianobi on October 08, 2014, 08:09:15 am

It seems to me that this problem is being overcomplicated, unless I have missed something. It seems that the OP would like the OBi110 to operate just as a desk phone connected to the PBX. How about an InboundCallRoute of

{iPhone1:li}

Any digits received will simply be routed through to the PBX



You are correct unless the OP needs the pauses.

Motohead:
no the pbx will "bank" any numbers after a 9 is dialed so i dont need any pauses

Motohead:
Quote from: azrobert on October 08, 2014, 07:58:17 am

Physical Interfaces -> Line Port -> DigitMap: (9|xxx|9xxxxxxx)

Then use:
{iPhone1>(Mli):li}

(Mli) refers to the Line DigitMap
Use this method to avoid defining the DigitMap in 2 places.

The above will allow these dialing patterns:
1) Dial 9
You will get dial tone from the PBX then dial 5551212
2) Dial 95551212
There will be no pause after the "9"
Will the PBX function properly with no pause?

If you need a pause do this:
Physical Interfaces -> Line Port -> DigitMap: (9|xxx|9<,,,,,>xxxxxxx|9,,,,,xxxxxxx)
<,,,,,> will insert 5 commas after the "9".
Each comma is a .2 second pause.

I never did the above. Hopefully I did it correctly.







so change the Physical Interfaces -> Line Port -> DigitMap:from (xxxxxxxS4|1xxxxxxxxxx|xx.) to (9|xxx|9xxxxxxx)

where does {iPhone1>(Mli):li} go?

Navigation

[0] Message Index

[#] Next page

[*] Previous page