OBI 200 with Cisco 7961/62 Dial Out issues -

(1/4) > >>

denk:
I have a obi 110 with a cisco 7960 in/out dialing is perfect for 4 yrs

now i have a obi200 and 7960 in/out dialing works perfectly too.

Now want to use  the obi 200 with the 7961/7962 but only inbound calls work and unable to dial out.  I've tried various version of the CISCO sip firmware but no joy.  the 7961/62 with the obi 110 only receives inbound calls no problem, able to pickup and has audio.

Turned off the obi 110 thinking its the 5061 port, still no outgoing calls from 7961 or 7962.

Looked at call history of the obi 110/200 it seems the dialed digits (from the 7961/62) are not being detected by both obi 110 or 200.

Tried just the "*" on the dialplan.xml but still digits not detected.  **n from the 7961/62 are not being detected also but 7960 seems to be perfect. 

any help or guidance would be greatly

azrobert:
I assume you are pointing the 7961 at SP2 of the OBi110 or OBi200.
Please post the X_InboundCallRoute of SP2.
Do these phones have a No Registration option?
Do you have an analog phone connected to the phone port of the OBi110 or OBi200?

denk:
in / out dialing from analog port for both obi's are ok.

Here's the sp2 X_InboundCallRoute for the obi200  (left unchanged)

{9255551212>(xxxxxxxxx):pp},{9255551212>(xx.):sp}       where 9255551212 is the cisco phone

the phones doesn't require registration.  at least I know the 7960 doesn't. 

Thanks.

azrobert:
Change the X_InboundCallRoute to: ph
If the phone port doesn't ring then the call isn't getting to the OBi.
If the call is getting to the OBi200 then the phone port will ring.
If the phone port rings then the call is not matching the InboundCallRoute rules.

The following is what I'm asking about registration.
Is the 7960 trying to register and failing, but still works.
or
The 796x phones have a NO Registration option.

denk:

the 7960 is fine with the obi 110.  the combination doesn't need to be fixed.  For the record, registration is disabled.

The 7961 can receive calls ok with Audio.  Registration is disabled both on the OBI and the SEPxxx.cnf.xml of the 7961/7962.  Its just i can't dial out from the 7961/62.  I looked at the history of the obi200 and it doesn't seem to detect the dialed numbers from the 7961/62.

I even went as far as reconfiguring the obi 110 to make it proxy to the 7961/62, again, just incoming, no outgoing, just busy after I press dial or let the timeout happens.

Thanks.

Navigation

[0] Message Index

[#] Next page