Ring Group separation

(1/3) > >>

Clivusmul:
Newbie here... I have a FreePBX Linux setup with multiple extensions and two incoming routes from Flowroute.  Just installed a new OBI-202 to hopefully improve CID shown on a Dish connected TV..  Everything seems to work great including FAXing however, the Obi-202 RINGS both analog ports whenever a call is routed to either ATA port by the PBX.  Substituting my prior Cisco ATA shows proper signaling of the analog ports.  A call to "line-1" rings the ring group associated with "line-1"; calls to "line-2" ring the proper lines... In the OBI-202, I have two (2) SIP setups with two distinct extensions (113 & 114) and both are properly registered with the Linux PBX machine.  The ring groups in the PBX are properly configured.  My guess at this time is that something is mis-configured in the OBI-202 causing both SIP lines to ring independent of which line was called; it is if they are slaved together... Suggestions on how to configure the OBI-202 to ring the analog phone ports independently/properly would be greatly appreciated.  Thanks, BobJ (Clivusmul)

azrobert:
Check the following in OBi Expert:

Voice Services -> SP1 Service -> X_InboundCallRoute: ph

Voice Services -> SP2 Service -> X_InboundCallRoute: ph2

One or both are probably set to: ph,ph2

Clivusmul:
Thanks for the very prompt reply!  Yes, the are both set to "ph,ph2".  I tried changing SP1 to "ph, ph1" but that did not alter the behavior.  The problem with this anomoly/mis-configuration is Line-1 is my voice analog line to cordless home phones and "Line-2" is my office FAX line.  The fax line is supposed to only ring to the fax machine and it is set to auto answer on the 2nd / 3rd ring.  If no one is home and a voice caller rings the house, after 3 rings the fax attempts to answer and there is no way for a caller to leave a message... Might be a great setup to discourage spam callers :) 

I will try the suggested settings and report!

BobJ

azrobert:
ph is short for ph1 and both point to Phone Port 1.

Clivusmul:
Thanks for the great prompt/configure advice... Now the ringing works properly... Next I need to know how to access messages from the analog phone with the blinking light... The old "*" code for dial voice mail in the FreePBX box seems to be directed to another use in Obi-202... I'll work on this for awhile!  Thank you again,
Bobj

Navigation

[0] Message Index

[#] Next page