Ring Group separation

<< < (3/3)

azrobert:
Quote from: Clivusmul on October 01, 2014, 12:30:48 pm

AzRobert, I copied the suggestion given in the forum for dial plan for Trixbox/FreePBx as follows and it works fine! 
(911S0|1xxxxxxxxxxS0|011xx.S2|xx.S2|xS2|xxS2|*X.S2|(Mipd)|[^*#]@@.)


The above DigitMap might cause you problems by routing the call too early. If you have a phone where you dial the number then hit Talk/Send then you won't have a problem. If your phone is taken off-hook when picked up, you might have a problem. The rules with a S2 suffix will cause a call to be routed if you pause for 2 seconds. Rule "xx.S2" will route the call early if you dial any number of digits and pause for 2 seconds. Even the DigitMap I suggested will route a 10 or 11 digit number early if you pause for 3 seconds after dialing 7 digits.

Navigation

[0] Message Index

[*] Previous page