can I adjust volume

(1/3) > >>

gworona:
Even when I adjust my phone volume to the lowest setting, the volume is way too loud - louder than when the phone was directly connected to my land line, before installing obi110.  Is there a way to configure the obi110 to send my phone a not as loud "signal"?

RonR:
Physical Interfaces -> PHONE Port -> ChannelTxGain : (-12 to 12)

Default value is 0.  Try -3 for starters.

Note: The OBi Device Administration Guide has the description of ChannelTxGain and ChannelRxGain reversed.

Billy2Hats:
So the TX is the mic and the RX is the speaker?

RonR:
Yes.  The description in OBi Device Administration Guide and the help '?' in the OBi have them reversed.

Fixed in OBi firmware update 1.2.1 (Build: 2384).

Billy2Hats:
Thanks Ron. Looking to fix an echo problem.

When we receive an incoming pstn call through the OBi110, we hear an echo of our own voice.

Outgoing SIP calls are fine, at least on SP1 have not tried SP2 yet. (I understand a prefix of **2 is the best wat to send the occasional call through SP2)
 

Navigation

[0] Message Index

[#] Next page