Help needed to set up A 1032 phone

<< < (3/3)

TrekCom:
I have followed your instructions but I end up with a amber light on the line that I have configured as the extension appearance and it won't work.  Any ideas?

Is there anyone working on getting the ObiPlus working with the 1032.  I would think this would be a prime project. 

Thanks,

Roger

MarkObihai:
If you are seeing an amber light then it's because the device isn't registering to OBiPLUS.  Can you confirm all of your settings have been configured correctly?  Did you put all of your settings into an unused SP/ITSP slot on the phone?  Also, did you use OBiExpert via the OBiTALK portal or the local device configuration web page?

For now, you treat setting up the OBi Phone via OBiPLUS just like you would any other device that doesn't have built-in OBiPLUS templates - that is follow the manual process.

There is another approach you can take that will give you most of the functionality that exists within OBiPLUS and will work "peer-to-peer" between the devices.  See the tutorial in this post:  http://www.obitalk.com/forum/index.php?topic=9104.0  - on the last page of this tutorial it's explained how to setup single stage dialling between devices and you can apply the earlier parts of the document to implementing extension dialling between devices.

Navigation

[0] Message Index

[*] Previous page