Blocking Robo Calls
SteveInWA:
Quote from: Taoman on December 18, 2016, 08:37:07 pm
I can't figure out how you guys are getting tf.arctele.com to work. I haven't tried configuring it as a gateway yet since I don't have that need.
I've been trying to use it as both a speed dial (to check specific numbers via Nomorobo) and also as part of a VoIP.ms ring group to run incoming calls through Nomorobo. Neither case works for me the way sip.tollfreeproxy.com used to.
However, tollfree.alcazarnetworks.com works great for me in all instances. So I don't really need arctele but it would be nice to have a reliable backup since it seems like tollfree sites are rapidly diminishing.
Also, toll free calls are working again using Sip Broker at Callcentric but still doesn't seem to be working with VoIP.ms.
I'm using it to fork the nomorobo calls in Voice Service-->SPx-->X_InboundCallRoute:
Code:
{(5nnnnnnnnn|6nnnnnnnnn|6nnnnnnnnn):aa},{ph1,sp2(18667326184@tf.arctele.com:5060;ui=$1)}
I did not test whether or not the port 5060 suffix made a difference, but it was listed on arctele's website that way.
azrobert:
SIP Broker is another option. It was down, but it's fixed now.
See: http://www.dslreports.com/forum/r31132671-General-SIP-Broker-Toll-Free-termination-via-CC-peering
You need to prefix the NoMoRobo number with a star like this:
spx(*1866732XXXX@sipbroker.com;ui=$1)
azrobert:
I had a config conflict when testing Denetron. It's now working for me.
Here is my list of tollfree providers:
tf.arctele.com
tollfree.alcazarnetworks.com
sip.denetron.com
sipbroker.com (prefix number with "*")
Taoman:
Quote from: azrobert on December 19, 2016, 06:43:54 am
I had a config conflict when testing Denetron. It's now working for me.
Here is my list of tollfree providers:
tf.arctele.com
tollfree.alcazarnetworks.com
sip.denetron.com
sipbroker.com (prefix number with "*")
Thanks for the info.
Turns out my problem when trying to use tf.arctele.com was that I wasn't prepending a "1" to the number.
All the tollfree providers you listed are now working fine for me.
However, Sip Broker still doesn't work on VoIP.ms using either network peering (**275*1800XXXXXXX) or SIP URI (1800XXXXXXX@sipbroker.com).
azrobert:
Quote from: Taoman on December 19, 2016, 09:50:20 am
However, Sip Broker still doesn't work on VoIP.ms using either network peering (**275*1800XXXXXXX) or SIP URI (1800XXXXXXX@sipbroker.com).
I never had a VoIP.ms account, but I assume the SIP URI should begin with an "*".
Navigation
[0] Message Index
[*] Previous page