Set up IdeaSIP as SP2

(1/2) > >>

Brian:
I am trying to set up IdeaSIP as SP2 (Google voice is SP1).  I used the following settings in ObiTalk:
Generic Service Provider Settings:
Configuration Name: Ideasip
Service Provider Proxy Server: proxy.ideasip.com
Service Provider Proxy Server port: 5060
Outbound Proxy Server: proxy.ideasip.com
Outbound Proxy Server port: 5060
Username: 1101xxxxxxx
Password: xxxxxxxx

In addition, I set the following using OBI Expert:
ITSP Profile B General:
STUNEnable: checked
STUNServer: stun.ideasip.com
X_STUNServerPort: 3478
X_ICEENable: checked

However, I see the following error for SP2 when I do that:
Register Failed: 479 (server=208.97.25.11:5060; retrying)

I contacted Obi support, but they did not know what 479 error code means.

RonR:
IdeaSIP works fine here.

Leave ITSPB -> General -> X_ICEEnable unchecked.

Leave ITSPB -> SIP -> OutboundProxy blank.

Make sure SP2 -> X_ServProvProfile is set to B.

Brian:
Still doesn't work.  I believe it is due to STUN settings.  I got this to work in softphone.  I disabled STUN server in softphone, then I was able to see the same error (479: private IP address not allowed).

RonR:
I'm using stun.ideasip.com on the OBi (SP2/ITSPB) and it registers and makes calls with no errors.

If your router has SIP ALG support, turn it off.

QBZappy:
Brian,

I googled "479 error" and found a DDWRT and an Asterisk post making references to External and inernal IP address in the SIP header. DDWRT was a firmware issue, and a configuration issue in Asterisk. Both posts making references to error 479. You would need to do a sip trace to have a better understanding of this issue in your setup. This might be a good starting point.

Navigation

[0] Message Index

[#] Next page