Set up IdeaSIP as SP2

<< < (2/2)

Brian:
I am running syslogd with following options to trace:
syslogd.exe -nl -s all

I set the following options to do tracing:
Device Admin:
Server: IP of Obi device
Port: 514
Level: 7

SP2 Service:
X_SipDebugOption: Log All Messages

I do not see any messages in the logfile, other than "Syslogd is listening to port# 514:".  Is there anything else I need to set to enable trace?

RonR:
Quote from: Brian on May 15, 2011, 10:07:51 am

Device Admin:
Server: IP of Obi device

This needs to be the IP address of the PC where the Syslog Daemon is running.

Brian:
It is working now.  Not sure what fixed it.  Thanks for your help.

Brian:
Obihai sent a firmware patch to my device to deal with the 479 issue.  It looks like that is what fixed the problem.

RonR:
Quote from: Brian on May 15, 2011, 01:56:30 pm

Obihai sent a firmware patch to my device to deal with the 479 issue.  It looks like that is what fixed the problem.

Are you talking about 1.2.1 (Build 2286)?

I verified yestereday that IdeaSIP was working fine with build 2283 and it had previously been working with 2103.

All's well that end's well, I guess.

Navigation

[0] Message Index

[*] Previous page