Obi 202 + IP Phone and Google Voice

(1/3) > >>

Banzai51:
Hello everyone,

   I want to connect an IP phone through the OBI202 to use it (for now) with Google Voice. I found these directions: http://blog.obihai.com/2012/08/use-your-obi202-as-google-voice-gateway.html and so far, GV is working fine (make and receive) on POTS line (phone 1 on the Obi), but my IP phone can receive calls, but it cannot make calls. When I try to make a call on my IP Phone, I get a busy signal and the phone says, "NO RESPONSE."

  Talked to support and we tried a few things including a factory reset of the Obi and IP Phone.

  I have a Grandstream GXP2140, and the only phone setting giving me pause is:

  SIP/Send Resp To Src Port = yes

 I'm not exactly sure what that is on the Grandstream. It doesn't have a setting with that terminology. Anyone know what the Grandstream setting would be? Anyone have a similar issue with using an IP Phone with an Obi?

Summery: POTS phone works fine with Obi and GV. IP Phone can receive but not make calls with the Obi and GV.

azrobert:
See: http://www.obitalk.com/forum/index.php?topic=8827.msg58429#msg58429

Banzai51:
Same end result, but now I can use my IP phone on my network rather than plugged into the Obi202. Step in the right direction.

Can receive calls, but cannot place calls with the IP phone.

azrobert:
Did the IP Phone register to the OBi202?

Temporarily make this change to see if the call is getting to the OBi202.
Voice Services -> SP4 Service -> X_InboundCallRoute: ph

Try another call.
Does the OBi202 Phone port ring?

If yes, look at the OBi202 call history.
Log directly into the OBi using the local interface.
Key the IP address of the OBi into a Web Browser.
Hit Enter
The UserID and default Password are both "admin".
Click Status on the left column.
Then click Call History.

It will show something like this: From SP4(xxxxxxxxx)
What is xxxxxxxx?

Banzai51:
Ok, checking the log...I don't see any outgoing. All incoming.

Plug the POTS phone into phone 1 jack, make a call successfully. Log now shows that call.

Call 1
From PH1     To GT1(phonenumber)...

The rest of the calls (incoming) show:
From GT1(phonenumber)   To SP2(Njoror@192.168.1.21:5060)

Config:

SP1 Service (Google Voice), X_InboundCallRoute: {SP2(Njoror@192.168.1.21:5060;ui=$1)},{ph}

SP2 Service (proxy for IP phone), X_InboundCallRoute:    {1001>(Msp1):sp1},{ph}

With 1001 being the AuthUserName configured on the SP2 service and the IP Phone.

Navigation

[0] Message Index

[#] Next page