Calling obi to obi or transferring call from 1 obi to another.
azrobert:
I had more mistakes than you posted.
I corrected the above config.
Here are the extensions:
OBi202#1 (IP Address 192.168.1.100) - Exten 100 and 101
OBi202#2 (IP Address 192.168.1.101) - Exten 200 and 201
w/IP Phone (IP Address 192.168.1.111) - Exten 202
OBi200 (IP Address 192.168.1.102) - Exten 300
w/IP Phone (IP Address 192.168.1.112) - Exten 301
Dranon2:
OK so I double and triple checked everything. Do I need to reboot the obi's? Calls out work and all but not the calling each others obi's
azrobert:
If you use OBitalk to configure your OBi's after you click Submit, the changes will be downloaded and the OBi will re-boot. You should wait until this process is complete before proceeding to the next configuration page. I don't know what will happen if you don't wait.
What happens after you dial an extension like 200?
Do you get a busy signal, silence or an error message?
Sorry, but I have to ask the next question.
Did you use the IP addresses I coded in my example?
I didn't say it, but I meant you to replace them will the real device IP addresses.
Dranon2:
100 & 200 long wait then"ext 201 has not received a response from the service provider" I cannot connect phone to phone but they all work outgoing calls.
I know what you mean BUT I did change the ip addresses to correspond with MY network and the devoices ip address.
When you say you dont use obitalk HOW do you set them up without it? I mean I setup then go into obiexpert.
Dranon2:
Quote from: azrobert on October 24, 2014, 02:16:13 pm
If you use OBitalk to configure your OBi's after you click Submit, the changes will be downloaded and the OBi will re-boot. You should wait until this process is complete before proceeding to the next configuration page. I don't know what will happen if you don't wait.
SOMETIMES THIS TAKES A LOOOOOOONG TIME!
What happens after you dial an extension like 200?
Do you get a busy signal, silence or an error message? dead air 30sec then the number you dialed 100 has not received a response from the service provider.
Sorry, but I have to ask the next question.
Did you use the IP addresses I coded in my example? No
I didn't say it, but I meant you to replace them will the real device IP addresses. I replaced them with my devices ip addresses.
Navigation
[0] Message Index
[#] Next page
[*] Previous page