The following is to add outbound calls to extensions for IP Phones.
userid is the Auth UserID of the IP Phone.
OBi202#2
Add to the beginning Voice Services -> SP4 Service -> X_InboundCallRoute:
{userid>200:ph},{userid>201:ph2},{userid>(Mp2p):sp3},
OBI200
Add to the beginning Voice Services -> SP4 Service -> X_InboundCallRoute:
{userid>300:ph},{userid>(Mp2p):sp3},
****************************************************
For "Out of Area", like I said above:
An easier change would be to show 100, 200 or 300 depending on the originating OBi.
Everywhere to see OBi202a, OBi202b and OBi200 in the config, change them to 100, 200 and 300.
I guessing here and I don't have time to test.
You might have to use a 10 digit number instead of 100, 200 or 300.
*****************************************************
Calling the IP phone:
A 404 response code is not found.
If you had the IP address wrong you would get a timeout, so I think this is a port problem.
You probably can setup several accounts on the IP Phone.
Check what port number you used for the OBi definition, then change 5060 to this port.
If this isn't the problem, maybe the number we send to the IP phone needs to match the Auth UserID.