forking from Obi110 to Snom320 on LAN

<< < (2/3) > >>

azrobert:
Voice Services -> Auto Attendant -> OutboundCallRoute
Add to the beginning:
{1:sp1(8005551212),sp2(anything@10.100.102.6:5060)},

Any number in the range of 1 thru 99 is interpreted as a Speed Dial.
The above will work if you don't defined Speed Dial#1.
I tried setting a Speed Dial to fork the calls, but it did not work.

Edit:
The above is how speed dials work from the phone port. I never tried a blank speed dial from the AA.

mrjoe:
Hi Azrobert.

Tried lots of variations but couldn't get the Snom to ring by giving it a local IP.

I got the following message when I tried with 5060
End Call (404 Not Found)

when I used port 5080 (which is the actual port that it uses to connect to the SP) it said it was forking but nothing actually happened.
While I would obviously prefer to have it going via LAN only I'm temporarily using 2 voipfone accounts to achieve it.

with regards to forking 2 outgoing calls, I'm getting a message: "The number you dialled 2 is invalid"

azrobert:
You said:
Quote

I can call from 1 of my Snoms to the other merely by dialing 10.100.102.5

What port does the Snom use for the outbound call?

I assume the Snom can have multiple accounts.
I think you should route the call to the port number associated with the account you defined on the Snom. I'm no expert on IP Phones.

Quote

with regards to forking 2 outgoing calls, I'm getting a message: "The number you dialled 2 is invalid"

You wanted to dial "1", not "2". Correct?
The number you dial must pass the AA DigitMap.
The default AA DigitMap will verify "1".

mrjoe:
It is built in to the system, even without internet connection or any identities it will work, see here:
http://wiki.snom.com/FAQ/Can_I_establish_pure_IP_calls_between_snom_Phones

With regards to the second thing, I did ensure that the number (2 in this case) was also in the dial plan and the outbound callroute as you advised.

azrobert:
This is what I tried:
AA DigitMap: Default
AA OutboundCallRoute: {2:ph,sp1(6235941000)}
Speed Dial#2: blank

I dialed 2 for Make a New Call then dialed 2 again.
My OBi110 re-booted. I assume it crashed.
My firmware level is 2824.
It should allow forking, so I believe this is a bug.

I then tried the following and it worked:
AA OutboundCallRoute: {2:sp1(6235941000)}

Navigation

[0] Message Index

[#] Next page

[*] Previous page