Obi100 Hear Nothing when answering and calling out

<< < (2/3) > >>

drgeoff:
Quote from: newinvestor23 on November 02, 2014, 08:00:28 am

It tells me my ip address and DHCP is enabled.
So I tried to factory reset obi100. Now I dial **9 222 222 222 and it says "there is no service available to complete your call"

Mine is saying the same just now, even though my two SIP services are registered.  Looks like Obitalk is down at the moment.

newinvestor23:
Should my freephoneline.ca work tho? because that was the original issue?

Mango:
Set the following:

Service Providers >> ITSP Profile X >> General
STUNEnable: (unchecked)
STUNServer: (blank)

You should also immediately remove your OBi100 from DMZ.  The OBi100 does not contain a firewall, and running a VoIP ATA without a firewall is a serious security risk.  If you have problems after removing your OBi from DMZ, we will solve them properly.

When you're finished, test incoming and outgoing calls and be sure you have audio in both directions.  Let me know if it works.

drgeoff:
Obitalk is back up.  Is **9 222 222 222 working for you?

newinvestor23:
Thank you very much Mango. After loading my configuration and updating my password, I called and received calls. Audio works both ways and echo test works too. I also took my obi100 off of DMZ.
I seem to remember putting the STUN server as I had a problem with audio I believe. Did something change with the stun server? Either way, it seems to be working.


Thanks again

Navigation

[0] Message Index

[#] Next page

[*] Previous page