UK PSTN caller-id not passed by Obi110
DeanUK:
Hi Mark,
The inbound call route from the line port has always been {ph}, except during some of the other tests described earlier in this thread when I tried to remove the “ character, however I now understand the PhonerLite test narrows it down to an Obi/phone issue. I’m using local Obi110 config on it’s IP address of 192.168.1.3. I have factory reset several times both from the web admin page and using a paperclip in the hole underneath the box. Now I’m using the BT Display 50 in between the wall socket on the Obi110 and can see the caller-id displayed on that unit, while the phone (“BT Your Phone”) connected to the other side of the Obi does not display it.
WelshPaul:
Well that's odd... thought I would test out the CallerIDTrigger again this morning but now when choosing either After Polarity Reversal or Before First Ring caller ID does not work at all.
It now only works when I select After First Ring.
I think the best thing is to leave it at it's factory defaults and only adjust them if you encounter issues.
Navigation
[0] Message Index
[*] Previous page