Quote from: giqcass on November 22, 2014, 12:29:04 PM
Quote from: YASH on November 22, 2014, 08:34:01 AM
But still, it brings that voice message of giving options of press 1 / 2 / 3 on dialpad.
I just tried couple of times,...
It still brings that dialpad pressing of options as usual,..
Try rebooting the Obi202 and see if the voice goes away.
EDIT: The easy way to reboot. From a phone connected to the Obi press *** then press 9 then press 1 to confirm.
Sir,..
First of all,.. thanks for your extreme cooperation and efforts,
with lots of tolerance,........ and without losing any patience, with me. Thank you, again.
BTW,.....I did exactly, like you said,.... ( ***9,1 on both the phones ) and Still that obi voice message was coming,..
I also turned the power plug OFF of the obi device, rebooted device,. and still the OBI voice message – ( " of pressing 1/2/3 options " ) was coming, as it is !
Finally, I found the remedy,... I went back to the "InboundCallRoute" area to check the status
ph,ph2 which was also fine,..
but this time,.. I took off the tic mark from that first column of the small square box there ( last time when I removed that tic from the second column, it had jumped to the first column to bring that ph,ph2 automatically.
[ As it was not letting me, repair those typings manually ]
So, ( now
no tic marks in any columns in front of "InboundCallRoute", has taken care of that annoying OBI voice messages with its options.
BUT,
The phone not ringing disorder (struggling 4-5 times
and then and then once only it rings the phone
- annoyance is as it is ! ( No matter,... I use Google chrome or Firefox )
When it rings the phone, via Google chrome, phone shows,..number as
29-040-0758
When it rings the phone, via Firefox, phone shows,..number as
00-000-0000
If I am logged ON, I don't need to enter the matching code, [ it never asks ]
If I am not logged ON, I need to enter the code.
But, regardtheless,...
a) whether I use firefox or Google chrome,..
b) whether I am logged ON or OFF
c) whether I dial by
1) entering device ID number ( 500xxxyyy ) or,..
2) In
speed dialing, selecting my device,.... and it brings
2* in the display area of the phone number or,...
3) entering
2*1302XXXYYYY [ 302 is my area code,..XXXYYYY is one of my OBI202's phone number allotted ]
it still does not always ring,..
and many a times, I listen to the first initial two fake rings,.. and then green letters shows "Ringing..."
and the phone never rings, even if I waited for another 10 minutes.