Setting-up OBI110 and OBI100 as Bridged and still allowing me to use GV
azrobert:
Which OBi is the GV SP trunk defined?
Is it SP1?
You only want to route international calls with a prefix of 011 to GV. Correct?
azrobert:
If GV is defined on the OBi110's SP1 do the following:
1. Set the PHONE Port in OBi110 to route international call out SP1:
Physical Interfaces -> PHONE Port -> OutboundCallRoute:
{(011xx.):sp1},{([1-9]x?*(Mpli)):pp},{(<#:>|911):li},{**0:aa},{***:aa2},{(<**1:>(Msp1)):sp1},{(<**2:>(Msp2)):sp2},{(<**8:>(Mli)):li},{(<**9:>(Mpp)):pp},{(Mpli):pli}
2. Set the SP2 Service in OBi110 to bridge incoming international calls to SP1 and all others to the LINE Port:
Voice Services -> SP2 Service -> X_InboundCallRoute : {>(011xx.):sp1},{>(Mli):li}
3. Set the SP1 Service in OBi110 to bridge incoming calls to OBi100:
Voice Services -> SP2 Service -> X_InboundCallRoute : {vg1,ph}
4. No changes necessary in the OBI100.
It already is routing all outbound calls to the OBi110.
artsmart:
Sorry Sir, I forgot to tell you that I haven't define GV yet and so I just did on SP1 of OBI110 and following the rest of your instructions based on your last reply. Just one question, with the current settings, will I be able to receive incoming and make outgoing local calls thru PSTN and also receive incoming and make outgoing local calls thru GV on both OBI110 and OBI100?
azrobert:
Quote from: artsmart on November 25, 2014, 03:56:56 am
Just one question, with the current settings, will I be able to receive incoming and make outgoing local calls thru PSTN and also receive incoming and make outgoing local calls thru GV on both OBI110 and OBI100?
Yes.
I have a typo in my last post.
It should be as follows:
3. Set the SP1 Service in OBi110 to bridge incoming calls to OBi100:
Voice Services -> SP1 Service -> X_InboundCallRoute : {vg1,ph}
artsmart:
It's ok sir I got it correctly, in fact I didn't notice that you have a typo error. Oh by the way, the two OBI's are behind NAT router and on the same subnet, I need to do portforward right? I saw 5060 and 5061, are there any ports that I need to forward too?
Navigation
[0] Message Index
[#] Next page
[*] Previous page