Setting Obi200 - Digitmap
azrobert:
You need OBiTalk provisioning enabled if you configure your OBi via OBiTalk.
I have ITSP provisioning disabled.
GAKW:
Is there any (easy) way to redirect calls that failed to another SP?
(Again)
I have
SP1 fpl
SP2 GV
Most calls within canada are free with fpl. But it they are not free they fail in the following manner
17:57:56 Call Ended (603 Declined)
Unless you have funds (but GV is free for those)
OzarkEdge:
Quote from: GAKW on May 26, 2015, 03:28:51 pm
Is there any (easy) way to redirect calls that failed to another SP?
(Again)
I have
SP1 fpl
SP2 GV
Most calls within canada are free with fpl. But it they are not free they fail in the following manner
17:57:56 Call Ended (603 Declined)
Unless you have funds (but GV is free for those)
If you can map them by digits dialed, you can route them before they fail.
OE
azrobert:
See:
http://www.obitalk.com/forum/index.php?topic=9975.0
I don't think a Trunk Group will failover with this type of error.
dima:
hello,
I've followed the config from this thread: https://www.obitalk.com/forum/index.php?topic=9107.msg64244#msg64244
setting up SP1 = FPL, SP2 = GV. I want to dial either US or Canadian number with or without '1'. International numbers will go to SP1.
my current settings are as follow:
Physical interfaces - PHONE 1
DigitMap:
([1-9]S9|[1-9][0-9]S9|*98|211|311|911|1xxxxxxxxxx|[2-9]xxxxxxxxx|011xx.S3|00xx.S3|**0|***|222222222|**[1-3]xx.S3)
OutboundCallRoute:
{**0:aa},{***:aa2},{222222222:pp},{(Msp1):sp1},{(Msp2):sp2}
Service Provider -> ITSP Profile A -> DigitMap:
(<1:>(236|250|778|403|587|780|825|306|639|204|431|416|437|647|807|249|705|226|519|548|289
|365|905|343|613|418|581|450|579|438|514|819|873|709|506|782|902|867)xxxxxxx|(236|250|778|403|587|780|825|306|639|204|431|416|437|647|807|249|705|226|519|548|289
|365|905|343|613|418|581|450|579|438|514|819|873|709|506|782|902|867)xxxxxxx|<**1:>xx.|18(00|88|77|66|55|44)xxxxxxx|*98|911|933)
Service Provider -> ITSP Profile B -> DigitMap:
(1xxxxxxxxxx|[2-9]xxxxxxxxx|<**2:>xx.)
Seems Canadian numbers work but when dialing US number, the message says "there is no call route available".
Wasn't ITSP Profile B Digit map suppose to catch non-listed in profile A area codes and route the call using GV ?
thank you.
Navigation
[0] Message Index
[#] Next page
[*] Previous page