Obi200 - Diverting calls to voicemail

<< < (3/3)

boon1:
Thanks azrobert. I could use AA to place a call out after pressing '2' upon hearing the messages.

I tried to call in my home phone (upon hearing messages) by press '1' but I was getting an error messages of "The number you dial 'zero' is invalid. How can I connect to my home phone by using this trusted caller id ?

From OBI manual, it mentioned upon pressing '1', The call will be sent to the PHONE port of the OBi and rung the attached telephone.

Thanks!

azrobert:
I only restored the New Call function for security reasons. That was the only function I thought you wanted. When a caller selects the "1" option, the AA sends a zero to the DigitMap then the Outbound Route sends the call to the Phone Port based on the zero.

Voice Services -> Auto Attendant
DigitMap: (1xxxxxxxxxx|0)
OutboundCallRoute: {0:ph},{(1xxxxxxxxxx):sp1}

azrobert:
It's very unlikely a spammer would make a new call without the prompts, but could accidentally enter a one to call you. The following DigitMap will prepend your callerid then the outbound route will only make a call from you:

Voice Services -> Auto Attendant
DigitMap: (<$1>1xxxxxxxxxx|<$1>0)
OutboundCallRoute:
{22233344440:ph},{(<2223334444:>1xxxxxxxxxx):sp1}

Change 2223334444 to your callerid.
I did not test this.

boon1:
Quote from: azrobert on December 20, 2014, 06:55:55 am

OutboundCallRoute:
{122233344440:ph},{(<12223334444:>1xxxxxxxxxx):sp1}


Yes, it's working perfectly. The only thing I need to add is the prefix '1' in front for my calling in number.

Also, I do not need to enter my calling number to the Trusted CallerID to Obi as it's already hard coded in the OutboundCallRoute.

Thanks again.

Navigation

[0] Message Index

[*] Previous page