Use both lines on Obi200

(1/2) > >>

thebonedoc:
I just got a Obi200 to replace my 100 so I can use the 2 line function.

I am trying to setup GV on one line (so any call made or received will only ring on Line 1)
And Phonepower on Line 2 to only ring and receive on this line.

I thougt this would be more straight forward to configure the line but I seem to be missing something

Thanks
Kenny

N7AS:
The OBi200 has only 1 phone port. Do you mean that you have an OBi202?

If so, If GV is on SP1 set Voice Services > SP1 Service > X_InboundCallRoute to {ph1}

and, if PhonePower is on SP2 set Voice Services > SP2 Service > X-InboundCallRoute to {ph2}

thebonedoc:
I have a 2 line phone and both lines get dial tone. I thought there would be a way to control each line independently. Yes this is on a Obi200

N7AS:
You can use a different ring profile for each SP. This way you can have a different ring cadence for each service provider.

azrobert:
Like N7AS said, the OBi200 only supports 1 line.
You could use the OBi100 for a 2nd line.
You can route outbound calls from the OBi100 to any trunk on the OBi200.
You can also route any inbound call on the OBi200 to the Phone Port on the OBi100.

If your 2 line phone has a single cord you would need a splitter to connect it to both boxes.
Post a reply if you are interested with this configuration.
In your post include your requirements.

Edit:
I was curious of what you said about dial tone on your 2nd line of your 2 line phone.
I don't have a 2 line phone, but I plugged a 2 line splitter into my OBi200 and the 2nd line was dead.
Are you sure you have a 2 line phone or do you have a single line phone system with 2 handsets?

Navigation

[0] Message Index

[#] Next page